JS FITTINGS

5k 10k JIS Slip-on Flange made of SS 400

Group Steel Pipe Flange JIS
Min. Order 100 piece
Terms of Payment L/C, T/T
Update Time 2020-07-24
Item specifics
BrandJS FITTINGS
SurfaceAnti-rust Oil, black painting, golden painting
PackagePallet and plywood cases
UsageOil, Gas and Water Pipeline
SizeDN15
5k 10k JIS Slip-on Flange made of SS 400
JS FITTINGS JIS B2220-1984 steel pipe flanges
Buy JIS B2220 Blind Flange and plate flanges, sli-on flanges, welding neck flanges in Cangzhou, China.

JS FITTINGS produce and supply 5k 10k JIS Slip-on Flange made of SS 400, such as SOP Flange 5K, SOH Flange 10K.

JS FITTINGS is an international supplier of JIS B2220 Flanges. The JIS B2220 Flange manufactured in carbon steel ss400, A105 for industries like Oil & Gas, Petrochemicals, Refineries, Thermal, Nuclear sector, Solar Power Plants, Atomic Energy, Defense and Aerospace etc.


It is welded both inside and out to provide suffcient strength and prevent leakage.

Slip-On Pipe Flanges. As made obvious by their name, these pipe flanges slip over the pipe. They're manufactured with an inside diameter that is slightly bigger than the pipe's outside diameter. These attachments are connected to the pipe via fillet weld at the top and bottom of the flange.
However, customers should bear in mind that this initial cost saving may be diminished by the additional cost of the two fillet welds required for proper installation. Moreover, weld-neck flanges have a higher life expentancy than slip-on flanges under duress.

Slip-on flanges are all bored slightly larger than the O.D. of the pipe. They are preferred over welding neck flanges bu many users due to their lower intial cost, but final intallation cost is probably not much less than that of the welding neck flange because of the additional welding involved.

Advantages of slip on flanges:

    Low cost installation
    Less time needed to spent on ensuring the accuracy of the cut pipe
    They are somewhat easier to align
    The slip-on flanges have low hub because the pipe slips into the flange before welding
    The flange is welded both inside and outside to provide sufficient strength
    They prevent leakage

A combination of flange and elbow or flange and tee is not possible, because named fittings have not a straight end, that complete slid in the Slip On flange.